foot size

If you haven't worn R.M.Williams footwear before and don't know your size, these are the directions R.M.Williams advise you follow.

outline your foot:  With your socks on and while in a seated position with your knee slightly forward, draw an outline of your foot onto a sheet of paper.  HOLD THE PENCIL STRAIGHT UP AND DOWN AT ALL TIMES.

measure your foot:  There are five foot measurements you need to take: joint, lower instep, instep, heel and ankle – see the diagrams.  Use a tape measure, drawn medium snugly, and measure completely around the foot.  Be careful to measure according to the lines in the diagrams.

joint – measure right around your foot, over the big toe joint and behind the little toe

lower instep – measure right around your foot, halfway between joint and instep

instep – with your knee slightly forward, measure around the foot, over the highest part of the instep, with the tape measure vertical

heel  – with your knee slightly forward, measure right around the heel at the point directly above the instep.  Do not raise your heel when taking this measurement

ankle – measure right around your foot, at the point directly above the instep

leg size
for high boots

measure your leg: There are three measurements you need to take:
height, top circumference and calf circumference – see the diagram.

height – measure from the floor to the centre of the small bone just below your knee on the outside of your leg

top circumference – measure around your leg over the same small bone

calf circumference – measure around the fullest part of your calf

measurements: